The concrete columns as a sensible thermal energy storage medium and a heater


ÜNALAN S. , Ozrahat E.

HEAT AND MASS TRANSFER, cilt.50, ss.1037-1052, 2014 (SCI İndekslerine Giren Dergi) identifier identifier

  • Cilt numarası: 50 Konu: 8
  • Basım Tarihi: 2014
  • Doi Numarası: 10.1007/s00231-014-1313-5
  • Dergi Adı: HEAT AND MASS TRANSFER
  • Sayfa Sayıları: ss.1037-1052

Özet

This study investigated storage possibility of sensible thermal energy in the concrete columns of multi-storey buildings and the heating performance of the indoors with the stored energy. In the suggested system, the dry air heated in an energy center will be circulated in stainless steel pipes through columns. The sensible thermal energy would firstly be stored by means of forced convection in column medium. Then, the stored thermal energy will transfer by natural convection and radiation from the column surfaces to indoor spaces. The transient thermal calculations are realized for a flat of the 11-storey building in Kayseri city of Turkey. The thermal energy requirement of the flat is nearby 5.3 kW as an average of a winter season. The simplified transient calculations were carried out over a concrete hollow cylindrical column having outer radius of 0.31 m and inner radius of 0.05 m corresponding an averaged column section in the sample flat. The flow temperature was selected between T = 350 and 500 K, which are considerably lower than the temperature of 573 K assumed as a limit for thermal strength of the concrete in the literature. The flow velocity ranges were selected between V = 1.0 and 5.0 m/s. The initial temperature was assumed as 293 K. After the first energy charging process of 23 h, for T = 350 K and V = 1.0 m/s, the total heat flux from the column surfaces into indoors are nearby 5.5 kW. The first charging time required to reach the energy requirement of 5.3 kW is decreased by increasing the flow velocity and temperature. Also for 5.0 m/s-350 K and 5.0 m/s-450 K, this time can decrease to 10 and 4.5 h, respectively. In addition, with 4.0 m/s-360 K or 2.0 m/s-400 K, after the energy charging of 8 h, the energy requirement of 5.3 kW can be provided by the energy discharging of 16 h and the energy charging of 8 h during 7 days. The results are very attractive in terms of the building heating systems of the future.